By illabeats
Mon Feb 04, 2008 11:38 pm
Last night I was messin around with my 500, makin a sequence whatever. Mind you , I got the MPC for Xmas, and all my samples have been safely stored in there for over the last month. Anyway, last night I turned the MPC off as I always do. Now today I go to load up my samples , and they weren't there. I took out my CF and loaded it into my PC and all the samples are on the card, but when I try to load the pads, they are not in the program I saved them. Do I need to re-assign all the pads over again. I don't understand how this would happen. I didn't do anything that I normally don't do. It's just a pain in the @$$ to re-assign all of them.