Save entire memory works......until I turn it on again. WTF?

I created a project with 7 sequences, put them in Song Mode - boom. done. I saved Entire Memory correctly, and it was fine. When I turned it off and reloaded it later, only 4 out of the 7 sequences would be loaded. I then manually tried to add the other 3, but when they were loaded (if they even worked at all), it said insufficient memory !!

STATUS:

WAV 29% SEQ 0%

(I do not have the RAM Expansion Card by the way; I have done more with this with no problems)

How is it that I can save everything once, but when I go back to it I get only a partial project??? A little help?

When you save entire memory your saving samples + creating Pgm & Seq files so these files may be taking up your what little memory you had before you saved. Definitely invest in the 128 ram and a 2 GB flash card, it will make your life allot easier!

Cold Snap wrote:When you save entire memory your saving samples + creating Pgm & Seq files so these files may be taking up your what little memory you had before you saved. Definitely invest in the 128 ram and a 2 GB flash card, it will make your life allot easier!

I understand, but I have only used 137MB on my 1GB CF Card, and there is still this problem. If I were to delete a folder that I am already done with, would it help? There are some projects that I have finished, and they're already recorded on my computer, so if I have to get rid of a couple things on the CF Card, it's not a big deal. What do you think?