Reviews and questions about the entry-level MPC500
By ChrisKeenoy Sat Jan 15, 2022 11:44 pm
Hey if it’s not too late, I ran into a similar problem like this on my MPC One. This problem just happened after the 10.2.1 firmware update. Whatever sample that was assigned to to pad 15, if any other pads in that same row (pads: 13, 14, or 17 ), were hit, it would trigger and play the sample that was on pad 15.

I went into the menu and adjusted the pad sensitivity and that stopped it. I think over time your pads and sensors get worn out from drumming on them. I don’t know about you, but I beat my pads up finger drumming.