Reviews and questions about the entry-level MPC500
User avatar
By JDSY Tue Mar 12, 2019 12:47 am
Hey,

So I have a old MPC 500 I'm playing around with, it's a lot of fun. But there's a few things. The main volume pot does nothing to change the volume. Also the left output doesn't produce levels and is eminating noise/sound.

Right now I just use a single 1/4 from R-out to a mixer and the drums are loud and clear. If I try to go from the Phones/ or left output I get noise/no sound.

I haven't tested the record in. . .

It didn't come with the 128 mb, so I'm just gonna see what I can do with 16. I already have 96 drum break samples saved to the internal memory, and they're taking up under 2mb so that is good.

You really do have to band on these pads. It's hard to be precise when you have to put so much power per tap.
User avatar
By JUKE 179r Tue Mar 12, 2019 10:54 am
The MPC500 is a little beast and definitely not a toy.

If you are good with taking the 500 apart, check the circuit board connections for the main volume and left output. The connections might need some soldering back onto the circuit board.
If you plan on increasing RAM memory later, keep in mind you'll need to buy a 256MB RAM stick in order for the MPC500 to have 128MB Max RAM memory. Don't ask me why but that is the way it is.
User avatar
By tapedeck Wed Mar 13, 2019 4:47 pm
the output and pot problem might be related. replace the pot and see if that doesn't fix both problems.
User avatar
By Null Sweat Thu Mar 21, 2019 2:31 am
I had about same issue with one I got off ebay. Volume pot not working. I had both channels but it seemed a little bias. Record pot worked. You could only adjust the master level in Mode + Pad 8 (Other) by 6db increments (or whatever it is). I bought a slider & volume pcb off of mpcstuff and it fixed everything. It was a easy install. Something like 3 screws and 3 wire connectors to replace the board. No soldering. https://www.mpcstuff.com/mpc-500-slider ... mbly-used/

My bets would be the volume pot, since it controls the gain on both channels, if you wanted to save some dough and can solder/desolder it yourself.