By Galik-C
Wed Oct 10, 2007 11:47 pm
2 problems: excuse the repost, but I got no responses the first time (YES I read the manual, and NO Akai tech support never got to me)
1. I was messing with the Q-Link Slider on one of the pads in a program I was working on. After I was done, I went back to finish up the sequence. Whether or not the "After" button is lit, the pad can still be changed just by moving the slider, so I have to change it again before I can finish the rest of my work. It's annoying the *#$% out of me, is there any way around it??
2. So I have created the sequences that I wanted to use, and put them in Song Mode. If I were to go and manually play them individually back to back, they are very fluid with their transition. But, when I put them in song mode, there is a small gap in between 2 of the sequences. Individually, the sequences are in different BPM. I set Song Mode to play them all as the same BPM, but only after I discovered this problem. It did nothing. Do I have to scrap one or two sequences and start over, or what?
1. I was messing with the Q-Link Slider on one of the pads in a program I was working on. After I was done, I went back to finish up the sequence. Whether or not the "After" button is lit, the pad can still be changed just by moving the slider, so I have to change it again before I can finish the rest of my work. It's annoying the *#$% out of me, is there any way around it??
2. So I have created the sequences that I wanted to use, and put them in Song Mode. If I were to go and manually play them individually back to back, they are very fluid with their transition. But, when I put them in song mode, there is a small gap in between 2 of the sequences. Individually, the sequences are in different BPM. I set Song Mode to play them all as the same BPM, but only after I discovered this problem. It did nothing. Do I have to scrap one or two sequences and start over, or what?