By ssnedden
Mon Nov 26, 2007 3:02 pm
Ok, so if I have a sound on a pad, adjust the filter, add effects, etc... and want to make that a new sound to clear out the effects for different pads, I just go to record - input:main, and record that sound. BUT, once the new sample is in trim mode I know it doesn't start at the same place that it did on the OG sample (there is a small gap, added when resampling), anyone know where to put trim start to get rid of this gap? Like the sample starts at "2205" and I think it should be at around "2505" to get it back to normal, but does anyone know exactly how much is added when resampling? Sorry if this was too confusing, but I want to know.