No joke: The "Baby-Steps" of Saving and Loading

I'll make it quick:

- When starting from scratch (i.e. Recording new samples, assigning them, etc.), what is the best way to SAVE everything in one place? Create a new folder from the beginning, or what?

- To load, do you load the Folder, the Program, the Project or All Sequences and Songs? Is there not an easier way to save/load your current "BEAT" or progress up to this point without accidentally going to the wrong location?

I'm not a complete KnewBee, but I've read the manual front to back and back to front so many times, I could have learned another language already.

a little help, beat bretheren. thanks.

Yo bro. I save "all seq/song" and "all sample program" in the same folder. Then i create a new folder inside the folder that i saved those other two. In this new folder i save all the sequences independently, because it's those that fukks up!

Sounds like it makes sense, but after it's all said and done, how do I Load the whole thing in one shot?

Save Entire Memory and load the project file.

Ocular wrote:Save Entire Memory and load the project file.

only way to go

Galik-C wrote:Sounds like it makes sense, but after it's all said and done, how do I Load the whole thing in one shot?

You just load the folder. The folder inside the loaded folder don't get loaded, if you understand me

OK, hopefully I can make more use out of my little friend other than using it for a paperweight. Thanks

all else fails, you can control Reason or Ableton with it

You can use it as a doorstop. It's great at it!