5k loop midi

I got my G6 midi to my 5k and my 5k midi a midi board but for some reason it won't loop the g6 sounds in the mp if I play them on either boards but if i play them on the pads I'm fine if I record them with the boards it always triggers 2 sounds I brought a few diffrent ppl over who know what there doin and they can't figure it out. They don't hAve this problem with there 2500 or 4k ... Should I just downgrade?

Soft Through (Soft Through Switch)
Thru function re-transmits all messages received at the MIDI IN
connector to the MIDI OUT connector without modifying them in
any way.
Value:
OFF, ONRemote Keyboard Sw
(Remote Keyboard Switch)
Set this parameter “ON” when you want to use an external MIDI
keyboard instead of the Fantom-G’s keyboard. In this case, the MIDI
transmit channel of the external MIDI keyboard can be set to any
channel. Normally you will leave this parameter “OFF.”
Value:
OFF, ONTurn this “ON” when you want to control the Fantom-G from
an external MIDI device when performing with the Arpeggio or
Chord Memory function.
Receive Program Change
(Receive Program Change Switch)
Specifies whether Program Change messages will be received (ON)
or not (OFF).
Value:
OFF, ONReceive Bank Select
(Receive Bank Select Switch)
Specifies whether Bank Select messages will be received (ON) or not
(OFF).
Value:
OFF, ONIf only a program change is received, and if the Live Set Control
Channel parameter setting coincides with the MIDI receive
channel of a part, priority will be given to switching the live set.

Transmit Program Change
(Transmit Program Change Switch)
Specifies whether Program Change messages will be transmitted
(ON) or not (OFF).
Value:
OFF, ON
Transmit Bank Select
(Transmit Bank Select Switch)
Specifies whether Bank Select messages will be transmitted (ON) or
not (OFF).
Value:
OFF, ON

Preset 1-128 (CC#0= 84, CC#32 =64 PC=1-128) User 1-128 (CC#0= 84, CC#32 =0 PC=1-128)
Preset 129-256 (CC#0= 84, CC#32 =65 PC=1-128) User 129-256 (CC#0= 84, CC#32 =1 PC=1-128)
Preset 257-384 (CC#0= 84, CC#32 =66 PC=1-128) User 257-384 (CC#0= 84, CC#32 =2 PC=1-128)
Preset 385-512 (CC#0= 84, CC#32 =67 PC=1-128) User 385-512 (CC#0= 84, CC#32 =3 PC=1-128) set to ON.

MSB-cc#84-LSB-64/then 1-128 and so on if your using the MPC to call sounds for each Patch or sounds etc.

*Note you might have to turn note off from the G6. to play sounds or volume down on the G6 keyboard. it's something simple