Problem at start with loading

Hi everybody, sorry for bad english > <
I have search but i can't find a problem like this..
I just buy an used Mpc 5000... But already have a problem. At start, when loading his stuff, i hear like a 'stack' from the hard disk. The screen reset and begin to loading again.
I notice that mpc doing this when i turn on after a time of not working.
Same problem when i go to Disk, then Usb then Mount. After i bit the mpc reset. Always in random way, not everytime, but a few time in a row.

O.S. updated to 2.0.
Everyone with same problem? I think maybe Hard disk is the prob. I already formated but nothing change.

Thanks for replace

Sorry, but it sounds like you bought a broken one. That is why I dont like buying used electronics.

> <
But once it starts it's solid, no crash in a couple of days. I turn off autoload, tomorrow i'm gonna see if there is the same problem.

I haven't already payed, 900euro. Was in a studio about 2 years always on...
Suggestion guys?
Maybe really the HArd disk? I made scan disk in usb/mount mode and no problem.

Today past something like 15 minuts before i can use mpc without continuos reboot.
One time it gives me (codec) failed error.
I think i take it back to my friend that give me and buy something new.

Anyone have ever had this problem?

The person who sell me this Mpc tell me he doesn't turn off ( never > < ) the mpc for 2 year.

Can be this the reason of the problem?

Hi there,

I think it could be a hard drive issue, try installing a new drive and test it.

I have a 5K too, no problems at all, it should load up quick if you've upgraded the memory to 192MB
If you hear the HD making a lot of noise on start up then it could be a HD issue.

Remove the internal drive and load a project from a CF card and see if the MPC acts in the same way.

Good luck.

Problem solved
Power supply semi destroyed. Bring to assistence 200 euro ; ;

Hallo, my mpc 5000 same problem (codec failed) may i know to fix that? Thank you