Autoload Trap (No memory available)

1. Added hard disc tracks to songs (bigger than the RAM)
2. Saved Entire Memory in the autoload directory
3. Switch off / on
> Display says: "No memory available"... and there is NO WAY to get out of this!
"Cancel" don´t work.

So...does anyone need a new MPC5000 as a spare part source, or is there a way out?

Thanks,
Jenny

jennifer wrote:1. Added hard disc tracks to songs (bigger than the RAM)
2. Saved Entire Memory in the autoload directory
3. Switch off / on
> Display says: "No memory available"... and there is NO WAY to get out of this!
"Cancel" don´t work.

So...does anyone need a new MPC5000 as a spare part source, or is there a way out?

Thanks,
Jenny

I think you can restore the auto-load to factory default by holding the erase key while turning the unit on.

you probably did a 'save entire memory' into an allready existing autoload folder with allready data (samples, seq , etc ) in it.
Then it's possible that this folder contains more data then the memory can hold.