Reloading

So I have yet to sucessfully re-load anything. I save as ALL, then load that. I see the sequences loaded but no samples, so u play and hear nothing. I save "entire memory" then when prompted make and name a folder. I see the folder listed, and when I open it, I see all the samples. So I highlight the folder and "Do It", but just the sequence loads. If i remember where everything was, I can start re-assigning to the correct pads in Program, but I thought these would load along with the all file, but so far I can't figure it out...

you have to save as "entire memory project", create a new folder and afterwards load the .prj (project) file into that folder

When you select the folder, and press load... try to use the "clear" option. Accept that, then follow thru with the load.

Thanks, I was reloading the folder, which had a pjk file but I guess if u load the individual pjk file that seemed to work. However when I load something that is an all songs and sequences, it loads sequencing data but no samples. Not sure what to do prob have to record it, b/c I don't remember where all the samples were (pad assignments), too bad.