By BrianGrassfield
Tue May 05, 2015 1:46 pm
Hi!
I built a good setup which focuses on silent working in the studio. Even my computer makes zero noise. Except the MPC5K. When I took a look on the PSU and the cooling fan, I noticed that 2 pin minimolex connector and a +12VDC line for source. Then I bought one of this Noctua fan because it has a 3 to 2 pin adapter with a DIY kit. Sadly it just didn't spin, so I had to put back the old one. Then I ordered a factory replacement hoping that the original just ran out, but the new still as noisy than before. So could anyone offer a good solution to replace the noisy fan to a silent one?
Thanks,
Brian Grassfield
I built a good setup which focuses on silent working in the studio. Even my computer makes zero noise. Except the MPC5K. When I took a look on the PSU and the cooling fan, I noticed that 2 pin minimolex connector and a +12VDC line for source. Then I bought one of this Noctua fan because it has a 3 to 2 pin adapter with a DIY kit. Sadly it just didn't spin, so I had to put back the old one. Then I ordered a factory replacement hoping that the original just ran out, but the new still as noisy than before. So could anyone offer a good solution to replace the noisy fan to a silent one?
Thanks,
Brian Grassfield