By polcure
Mon May 06, 2019 1:37 pm
Hi
I've got a mpc5000 which was barely used. Only used a few times in 2015. I fired it on it boots fine and shows correct ram and firmware.
When pressing mode and any pad function nothing happens. The corresponding buttons seem to trigger other function. The navigation buttons only work with the right button.
I factory resetted using the usual erase button when powering on.
I opened it up and checked all ribbon cables and to see if there were any bad capacitors etc. All seem visually fine.
I'm just wondering if a flat lithium br2325 is the culprit. Has anyone had to change the lithium battery out.
Regards
M Patel
I've got a mpc5000 which was barely used. Only used a few times in 2015. I fired it on it boots fine and shows correct ram and firmware.
When pressing mode and any pad function nothing happens. The corresponding buttons seem to trigger other function. The navigation buttons only work with the right button.
I factory resetted using the usual erase button when powering on.
I opened it up and checked all ribbon cables and to see if there were any bad capacitors etc. All seem visually fine.
I'm just wondering if a flat lithium br2325 is the culprit. Has anyone had to change the lithium battery out.
Regards
M Patel