Anyone getting ( computer stopped communicating) message in

inside logic I get a spinning ball and the ren hardware screen says computer stopped communicating.....

when I try an click on the plug in tab to open the gui, does it in 32 bit bridge and regular 32 bit.

But I am getting much better loading capabilities now that I checked the 1mb limit option in preferences
Going to test it in a real session today, If I could just get that communication error to leave

I have the same problem, only it's the regular program not even using it as a plug-in

**** wrote:

dorsey wrote:If Nukai could just get that communication error to leave

you know dam well that's not what he said. you are really pushing it. STOP

I have found if you go into device Manger and go to USB controllers and find your mcp in USB Root Hub property , select the power management tab and deselect Allow the computer to turn off this device to save power, fixed the problem.

I changed my usb cable, the one it came with was dodgy