Step Seq Mode is broken when t.c. is 32

Anyone with a Ren(or studio i guess) go to step sequence, and set your T.C. to 32nds. Make sure your sequence is at least 2 bars. I usually have it 4 bars.

Now go to STEP SEQ (where you sequence 808 xooxoxo style and the pads light up) Make sure you do this and resolution is set to 32.

Now is it me?... or can you only edit the first half of a measure/bar when the Ren is set to 32 tc in Step Seq mode? It works but only the first half of bars. Step Seq works fine when tc is on 16ths, but not when its set to 32nds.

Anyone with the ren/studio can you please test this out because I havent seen anyone mention it.

bump

can someone else please try this out and confirm if you they having the same problem?

I'll check it out when I get back home.

Just tried it and it works just like you described it. It seems like you're able to access "the other half" of the bar by switching PAD BANK to B.

It works if you switch to pad bank B? im about to try now

Yeah you're right, if I switch it to bank B then I can access the rest of it. To be honest I think I like this alot better than how it used to work, but I think that they should've documented it so that we didn't have to discover it on our own.

InspectahEX wrote:Anyone with a Ren(or studio i guess) go to step sequence, and set your T.C. to 32nds. Make sure your sequence is at least 2 bars. I usually have it 4 bars.

Now go to STEP SEQ (where you sequence 808 xooxoxo style and the pads light up) Make sure you do this and resolution is set to 32.

Now is it me?... or can you only edit the first half of a measure/bar when the Ren is set to 32 tc in Step Seq mode? It works but only the first half of bars. Step Seq works fine when tc is on 16ths, but not when its set to 32nds.

Anyone with the ren/studio can you please test this out because I havent seen anyone mention it.

This is a case of RTFM.