MPC Renaissance & Roland Integra 7

Hello fellow MPC brethren my setup consists of the MPC Ren and the Roland Integra 7. Roland recently released an Integra 7 Editor VST for Mac so now I want to use that VST in the MPC DAW. Before Roland released the VST I had my output in the MPC DAW set to my UA Apollo Quad interface and the input set to the Integra 7 interface. I can open the Roland Integra 7 VST but I can hear no audio. I also hear latency during playback, most likely since I haven't added the Thunderbolt option, but anyways please help!

Can't offer much but I know on My Fantom if you want to use the VST aspect you have to use the Fantom as your audio interface, and my interface is much better so I end up not using the VST Editor aspect.

This thread at Roland Clan might give a starting point to look into your problem, although the thread is prior to the VST being released, but is focused on the output and audio over USB aspects.

http://forums.rolandclan.com/viewtopic. ... 8&start=15

If this is old to you and you've been at Roland Clan, apologies, just hoping you find a clue there to start figuring it out, good luck .

@latifthegr8 wrote:Hello fellow MPC brethren my setup consists of the MPC Ren and the Roland Integra 7. Roland recently released an Integra 7 Editor VST for Mac so now I want to use that VST in the MPC DAW. Before Roland released the VST I had my output in the MPC DAW set to my UA Apollo Quad interface and the input set to the Integra 7 interface. I can open the Roland Integra 7 VST but I can hear no audio. I also hear latency during playback, most likely since I haven't added the Thunderbolt option, but anyways please help!

Try setting the MPC input and output to UA Apollo. Your Apollo outputs should be connected to your Studio Monitors.

Connect the Integra 7 outputs to the Input 1/2 or 3/4 of the Apollo.

Cool that solved the problem as far as audio, but how do I go about getting my midi controller to sync with the VST?