mpc studio/m audio 10/10 lt delta no audio help plz

hi ya
im new to the forums and could do with some advise about setting up the mpc
studio with the 10/10 lt audio iface on windows 7.

the mpc is new and software has been installed as per instructions supplied
expansion packs have also been installed and have updated all to latest versions
but cant get any audio out from the 10/10lt in audio pref window have selected asio
m audio 10/10 and if you press the test button you hear a tone so it should work
but cant get audio out even tho the meters on both mpc studio and 10/10 mixers are showing a signal but no audio output.

The audio card works fine apart from when trying to use mpc.
have uninstalled and re installed all software and drivers a few times with no change

its very frustrating to have brand new unit and not be able to use it can any 1 shed any light on this pleaze

Cheerz bAz

I had an m-audio audiophile 192 and I had to use asio4all. I would get the test tone but no sounds. the software would route sound to the analog output and I was using the digital output.

I actually use that exact card everyday in my studio PC.

Make sure you have gotten the latest drivers from M-Audio for your version of Win7.

The Delta series has their OWN ASIO Driver. In the MPC Preferences, make sure you are using the correct device!

hi
cheerz for the help tried the asio4 all with no joy didnt think that would work as the 10/10 has its own specific asio, updated the drivers for sound card still no joy.
as a last resort thought would try routing studio thru the on board soundcard to see if it would work and bingo for some reason it will use the 10/10 but only if routed thru the onboard sound card it wont if routed directly to 10/10 wtf still its workin now
will sort the routing prob later cheerz bAz

Glad you were able to at least get rolling. If you have any other questions about that setup. Drop me a PM, I can help.