How to assign and save parameters on q-link knobs

When I was using my akai mpd26 with Studio One, I had it set up to where I could assign volume, tranpose, tune, filter, cutoff and resonance on all 6 knobs and each knob affected all 16 pads. and saved it as a template. I basically want to be able to do that with my friend's MPC Renaissance on the MPC Studio program. Is that possible, and if so, how do I go about that. I'm new to this so any help is greatly appreciated.

Thanks

not in front of mine right now, but its pretty much:

assign Q-Links as you like > file > save as > change to 'template'...

then when you start a new session you can just go to 'new from template'

its roughly like that....