By flone
Sun May 02, 2021 1:42 pm
This is my first post here because I haven’t found any thread that fits my problem.
So 3 of the Q-Links on my Ren are broken I think. When it set them to a value they keep jumping about 3 values higher and lower and don’t settle on the one I put.
I can’t tell for how long this issue is already there because I just picked it up last week. Of course my pre owner knew nothing about it
I don’t think it’s a software issue because it’s really just on 3 of the knobs, the other ones work perfectly fine.
I found replacement knobs on mpcstuff.com so my question is: how big of a deal is it to replace these knobs? Has anyone done it before? I can’t find any videos or tutorials whatsoever
So 3 of the Q-Links on my Ren are broken I think. When it set them to a value they keep jumping about 3 values higher and lower and don’t settle on the one I put.
I can’t tell for how long this issue is already there because I just picked it up last week. Of course my pre owner knew nothing about it
I don’t think it’s a software issue because it’s really just on 3 of the knobs, the other ones work perfectly fine.
I found replacement knobs on mpcstuff.com so my question is: how big of a deal is it to replace these knobs? Has anyone done it before? I can’t find any videos or tutorials whatsoever