Brick Reset

My MPC Touch would no longer be recognised by my pc after a vst crash. I tried removing everything, reinstallation and any other advice I could find to no avail. After seeing a post about somebody finding a reset switch inside a mpc One, I decided to open up my Touch. I found the following;can somebody please tell me how I can use this to perform a reset?

https://drive.google.com/file/d/17UcJQa ... p=drivesdk

Thanks for the heads up. Can't fond options to edit OP so I'll post the link here:

unplug the power supply, then press the power on switch a couple of times
(this most likely will discharge capacitors buffering power on board)
then plug in power again and start
(the procedure doesn‘t work always, but in many cases)

ps: there may be a key combination mentioned in the manual for reset to default

No panel buttons work, but are lit up, screen shows nothing after power up logo, but I'll be sure to give the power switch method a try, thanks for the suggestion, nothing else has worked.
I was hoping somebody may know how use the hole labeled 'reset' on the pcb, there's nothing on the Internet