By Lironvan
Mon Jan 18, 2021 10:43 pm
Hi everyone,
I'm new to the subject of Midi Controllers. Was anyone of you able to set up the MPD232 in the MPC Beats Software properly? When using the factory preset in the software, pads are changed. When using the Midi Learn function, I'm not able to assign the knobs correctly.
I would like to use them for the q-links in trim and chop mode, but when turning the knob, there is no difference between start X 1 or start X 1000 q-link for example.
Which presets on the controller do you use and how to set it up in the software?
Thanks for your help!
I'm new to the subject of Midi Controllers. Was anyone of you able to set up the MPD232 in the MPC Beats Software properly? When using the factory preset in the software, pads are changed. When using the Midi Learn function, I'm not able to assign the knobs correctly.
I would like to use them for the q-links in trim and chop mode, but when turning the knob, there is no difference between start X 1 or start X 1000 q-link for example.
Which presets on the controller do you use and how to set it up in the software?
Thanks for your help!