By Sooty_G
Sat Jun 15, 2013 10:52 pm
just emailed this to Murai:
1. load a sample to pad 1
2. goto TRIM mode
3. turn PGM MODE on
4. turn loop to ON
5. hold down pad 1 while adjusting the START, LP, or END value
BUG: a sample becomes stuck in loop mode. it does not stop looping when you release the pad. you need to press the STOP key to turn it off.
1. load a sample to pad 1
2. goto TRIM mode
3. turn PGM MODE on
4. turn loop to ON
5. hold down pad 1 while adjusting the START, LP, or END value
BUG: a sample becomes stuck in loop mode. it does not stop looping when you release the pad. you need to press the STOP key to turn it off.