[bug] Looper OUT problem

this looks like a bug

If you switch the OUT in looper from ST to the other outs you wont hear yourself recording in the first pass. The signal goes to ST and only after it loops one time does it go to the specified out.

Hi,

Is it the same with out 4?

I can't try myself right now but in the manual you can read this :

Output destination field
The output destination of the recorded sound is set.
Notes
The pads sound will always be outputted to ASSIGNABLE MIX OUT 4. (in the case of MPC1000)
The pads sound will always be outputted to ASSIGNABLE MIX OUT 8. (in the case of MPC2500)

Maybe it has an influence on what you're trying to do.

I've had this exact problem, I've not tried setting it to 4, but then even if that worked I'd have my signal in mono. Seems like this should be perfectly fixable if it is a bug.

L

Just in case you didn't notice it before:

Notes
In a looping recorder mode, all are pronounced by a mono. (Use in a stereo cannot be performed)
The sample of a stereo is also pronounced by mono.

http://www7a.biglobe.ne.jp/~mpc1000/os2xl/looper.htm