[misguided post] fx routing bug jj os 2xl 3.18 mpc 1000

I just upgraded to latest jj os 2xl for mpc 1000 3.18.

In the mixer mode/ fx send I am now unable to route program mixer channels to fx.

above each pad eg. A10 there is -- that cannot be changed to be routed to either fx1 or fx2 with the Data wheel.

Thank you ahead of time for looking into this. I love the jj os!!!

jjosxl 3.18 is not the latest. 3.19 is.

however, you can only route tracks/pads to the fx channels if their outputs are set to ST.

from jj´s website:

Note: Selection is possible only when ST is select in the OUT column.