3000 BACKLIGHT,NO SOLDERING REQUIRED

Share your knowledge on these two classic MPCs
 Reply Share on Facebook
User avatar

Re: 3000 BACKLIGHT,NO SOLDERING REQUIRED

By b.read Thu May 12, 2011 1:50 pm
Yep...that's Matt.
User avatar

Re: 3000 BACKLIGHT,NO SOLDERING REQUIRED

By b.read Fri May 13, 2011 5:02 am
No prob...tell him b.read sentcha :lol:

Re: 3000 BACKLIGHT,NO SOLDERING REQUIRED

By mpc3000le Sat Jun 18, 2011 10:42 am
monogee wrote:I just bought one. Hope this makes my MPC3000 look new. :D


I fit one of these back lights to a friends MPC3000.

Good quality, well cut and shaped.

I recommend though that you do remove the old back light prior to fitting one these pre-wired new ones.

IE: Fit in place of the original rather than over the top of it.

Rohan.
User avatar

Re: 3000 BACKLIGHT,NO SOLDERING REQUIRED

By b.read Sat Jun 18, 2011 4:46 pm
I agree...I know there was some debate on which product was which, the non-solder backlight that goes on top of the old light, or the one in which you remove the old light.

This is the one is designed for you to remove the old one. :wink:
User avatar

Re: 3000 BACKLIGHT,NO SOLDERING REQUIRED

By smokemachine Wed Jun 22, 2011 2:18 pm
the one i bought from MPC Stuff had these little copper tabs.

i guess you just wrap them around. i soldered them shits just to be safe.

i think the price was a little crazy though ($40).
 Reply
Return to MPC3000, MPC60