sent in for repairs and now my scsi isnt working, need hepl!

I sent my 3000 in to get the stop button and a couple other buttons fixed. they fixed it, tested it, then sent it back. nowthe scsi isnt being recognized. i was wondering if there iss a simple fix or what i can try out to get it to work, thanks

hydroslanger wrote:I sent my 3000 in to get the stop button and a couple other buttons fixed. they fixed it, tested it, then sent it back. nowthe scsi isnt being recognized. i was wondering if there iss a simple fix or what i can try out to get it to work, thanks

Sounds like they didn't connect the SCSI board back up properly.

Repair should be covered by warranty.

Speak with the repairer.

( note: Inernal SCSI cables may have become un-seated during transit ... or not re-connected in the correct manner by the service folks when they were working on other stuff. )

Rohan.