Enter button don´t work

My enter button don´t wanne work any more.

What can I do?
Thats make me ill

Get a new one and put it in.

were can i get this kind of button?

http://www.mpcstuff.com/mpc300060-buttons-set-.html

This one 4 my mpc60 mk1?

VST Service has them too.

thanks but did vst service ship to europen?

I believe they do but not 100% sure

This morning the button works but more wrong as good.

What did you mean is it he button or could´t it be a damaged contakt?

Greets

IF you have to order them, buy at VST, they are usually much cheaper. Those purple buttons for example cost only half of what they do at MPCStuff (like most of their other stuff too...).

They do ship to Europe and are very reliable.

But I rather think it's the button switch itself, which isn't as easy to replace.

I think maybe it's not the plastic button part that VST has (and yes, they do ship to Europe, I just bought a backlight-invertter from them) but the tactical switch underneath the plastic button.

I bought 50 or so of these from Mouser, if you search this forum you will find a link to the part. You have to desolder the old switch and solder the new one.

In my order it says:

688-SKHVBE
ALPS Tactile Switche
6.0x6.0x5.0mm 160gf

Or maybe you can "clean" it, but I have no experience with that.

Could somebody told me PLEASE what the tacticle switch is?

Thanks

http://www.mouser.com/Search/ProductDet ... 4Jyg%3d%3d

Is this the button or what is it?

I have to replace my buttons

When i got my mpc 60 , half of my butons didn't work , i just spray some contact cleaner on the switches ( after take out the command PCB board ) and since everything works perfect , you should try it ( as long it is not a mechanical issue like a loose switch ) , by the way the spray is called kontakt 60 ( german stuff i think ) .
the tactile switche is the thing soldered on your PCB ( board )

pieuvre wrote:When i got my mpc 60 , half of my butons didn't work , i just spray some contact cleaner on the switches ( after take out the command PCB board ) and since everything works perfect , you should try it ( as long it is not a mechanical issue like a loose switch ) , by the way the spray is called kontakt 60 ( german stuff i think ) .
the tactile switche is the thing soldered on your PCB ( board )

Agreed. Takethe top off the MPC and Spray some contact cleaner lubricator in the tact switches under the plastic buttons.

CLEAN YOUR MPC!

Thanks for the answer I will try it will write back in this topic