MPC 3000 SCSI Kit for internal & external ZIP/Card reader *F

No, not that, that splits one 4 pin Molex power cable out to two SATA power cables.

You might have to use a couple of adapters.

You need to get from the internal floppy power cable, to one floppy power plug and one 4 pin Molex power plug.

ok. thanks. will be searching... when i have found everything i would like to compile a list of everything that i is needed. not so easy for us clueless non-techies.

**EDIT**
not an easy task... any help appreciated.
also still searching for the external DB25 to internal IDC50 adapters. have not found it anywhere so far.

jimmie wrote: I found firmware 3.85 to work the best.

I meant 3.88.

okay... seem to have everything now

here i have found the missing power cables that will work with the ACARD and the Delock Card Reader:
viewtopic.php?p=1407893#p1407893

Just to be sure: the scsi cable that goes out from the board with the memory and OS on it is no longer needed, right?

*edit*

Second question: i have made all changes according to the guide on page 1, but i forgot to put a Scsi Terminator onto the outgoing DB25-IDC50 adapter. I assume that is causing my current problem: i switch on, system is booting, but then no button is clickable... Or is that caused by another mistake i made?

Phewww... Fixed that problem with the non-working LEDs and Buttons. A cable underneath the Scsi output at the back that is connected to the Pads and stuff had secretly gone disconnected.
Heartrate back to normal.