Set the pads to chromatic?

Hi,

sometimes I like to use the pads of my mpc3000 to trigger sounds in logic EXS24 software-sampler.
so I tried to create a MPC program witch is chromatic from c1-c5.

the problem is, when I set the pads to the right note-numbers, 3 or 4 of the 64 pads doesn't will send midi to logic?
The pads are o.k.! If I put internal-samples in the MPC to these note-numbers , the pads work correctly!?

What I doing wrong?

thanx

schmitti

Check to see if you have any of them set on note off or mono, also check to see if any of the pad are assigned to trigger (cutoff,simult,etc.).

The best way to approach this is to do a factory reset and create a new program, this way you dont have to search for the error.

hope that helps.

thank you:-)