By Flub
Tue Dec 30, 2008 12:41 pm
Hey there,
I just cleaned the pads on my mpc 60 mk1 and then I put it back and tightened all the screws.. but I can move the pad 2/ 3 mm around ... I think that I couldnt move them the same before cleaning them... what could it be that normally hold the pad.. die nobs are in there place.
I just cleaned the pads on my mpc 60 mk1 and then I put it back and tightened all the screws.. but I can move the pad 2/ 3 mm around ... I think that I couldnt move them the same before cleaning them... what could it be that normally hold the pad.. die nobs are in there place.
http://www.soundcloud.com/mephistomc
Need MPC60 / ASQ10 SCSI Expansion ?
Need MPC3000 new high contrast LED display? write me !
Need MPC60 / ASQ10 SCSI Expansion ?
Need MPC3000 new high contrast LED display? write me !