Can you limit the velocity range on the MPC-60

heya,


just digging into the 60. is there a way to limit the dynamics, for example, so that when pads are hit they only sound from 35-100 instead of 0-100? If not, any recommendations? I'm getting great results on 'full level' mode, but my dynamics are a little to dynamic at the moment! cheers g

16 levels velocity... and practice triggering with full level turned off.

Yeah if you look for it, there should be a velocity->level parameter. By default it is 100 but you can change that for each individual sound.

Harmoncj wrote:Yeah if you look for it, there should be a velocity->level parameter. By default it is 100 but you can change that for each individual sound.

If anyone can direct an idiot to this menu, I'd be much obliged!

faeriepunk23 wrote:

Harmoncj wrote:Yeah if you look for it, there should be a velocity->level parameter. By default it is 100 but you can change that for each individual sound.

If anyone can direct an idiot to this menu, I'd be much obliged!

trouble is I've never actually used the 60 myself

it is described on page 116 of this manual though

link to pdf os 3.1 manual

....
press the SOUNDS key, then select option 2.
....
The Vel Mod (Velocity Modulation) section:
...
• The Volume field:
This field sets the amount of effect that note velocity has on volume (0–
100%). If set to 0, note velocity has no effect on volume; if set to higher
values, the volume will decrease as you play lower velocities.

That's FANTASTIC!!! Thanks so much!!!