Merging Programs

Hey there,

i have the following szenario:

i loaded a template program from my CF Card from Partition A. In addition to that, i want to load on top of that a Program from Partition B.

Here my Question:
is it possible to merge the two programs?

I know it is possible to load a new program in addition to the previous one and assign the samples of it to the old one. With more than 16 Samples its a little bit inconvenient.

Example:
i use REX Files a lot.Pad Banks C and D are reserved for sliced Loop (16 Slices for each Bank). At the moment i assign each Slice manually to the program.

Tarelizer wrote:Hey there,

I know it is possible to load a new program in addition to the previous one and assign the samples of it to the old one. With more than 16 Samples its a little bit inconvenient.

Inconvenient in the MPC but not using PRGMmaker or RS-16x. How about just creating a new program using either of those?

i have a lot programs for OSX and Win to create MPC Pgms. Translator, REX2MPC, etc.

I can assemble programs on the computer, of course. But it would break down my flow.

When i´m on the MPC the computer is mostly switched off. I want to try new ideas, new sounds directly.