By HillBrothers5
Sat Feb 23, 2019 6:03 pm
I recently picked up a vintage AKAI MPC3000 and am attempting to bring it back to life.
INITIAL ASSESSMENT:
1. System begins to boot up at POWER ON
2. System Version 3.11
3. Screen Displays "Loading Files" and progresses for about 15 seconds then ..
4. Screen Displays "Searching SCSI for Hard Disk" and HANGS UP
5. System does not respond to SOFT KEY 4 <CANCEL> input
RESEARCH
1. Symptoms indicate fuse F901 on the SCSI PCB may be blown
NEXT STEPS
1. Checking for continuity across fuse F901 on SCSI PCB
I'm brand new to the AKAI MPC3000 but have a background in electronics service and repair.
Any suggestions would be appreciated!
Thanks
INITIAL ASSESSMENT:
1. System begins to boot up at POWER ON
2. System Version 3.11
3. Screen Displays "Loading Files" and progresses for about 15 seconds then ..
4. Screen Displays "Searching SCSI for Hard Disk" and HANGS UP
5. System does not respond to SOFT KEY 4 <CANCEL> input
RESEARCH
1. Symptoms indicate fuse F901 on the SCSI PCB may be blown
NEXT STEPS
1. Checking for continuity across fuse F901 on SCSI PCB
I'm brand new to the AKAI MPC3000 but have a background in electronics service and repair.
Any suggestions would be appreciated!
Thanks