Share your knowledge on these two classic MPCs
By 2wice Fri May 13, 2005 7:47 pm
I noticed in the 310 manual that your system parameters should be saving while you turn the machine off. Mine are not, Im guessing this means my battery is bad... Its really no big deal since I just save my params with my song or program to disk, just wondering if anyone else has this issue.

By elmacaco Fri May 13, 2005 8:53 pm
Oh man, I had my battery die and yeah, you can tell because it won't save your midi channel names and such. I replaced the battery, but it was probably the hardest thing I had to do on my 60, because you gotta remove the system board, and that had me sweating bullets, and removing the battery is no joke because it is soldered in, and if you over heat it it can explode!! leaking acid everywhere causing more problems.

A tech should be able to fix it for about $50-$80, maybe cheaper depending on where you go, but I would say get it fixed when you can, and have them put in a battery holder so next time you just pop a new one in from radio shack, that's what I did. They last about 10-15 years. I guess you could do without it, but it is nice to have that battery up remembering your little settings and such.

By 2wice Fri May 13, 2005 9:19 pm
Thats silly it doesnt just pop out like a pc but I guess in those days cmos was soldered to the mb. Its kinda funny my 60 is such a hoopty... Its rusty too haha

By elmacaco Fri May 13, 2005 9:26 pm
just be thankful it was a disk battery type, those cylinder plasic typres are harder to deal with. f you know how to solder and can do this kind of work it isn't difficult, well, yeah it is a little bit, better to just get tech to do it when you are ready for it, or just save a params file on a floppy always in the drive when you boot up.