Broken side arm on MPC3000LE...Can they be replaced?

I just purchased an MPC300OLE. The unit is fine but the top corner of the side arm is broken. Are these parts available anywhere? Thanks for your help.

[/url]

Try VST in pasadena, They are the best I've dealt with.

http://www.vstservice.com/

Thanks so much. I just emailed them.

I got some sides for my 60 from them a while back, I think they were $30 + shipping.

Man, I'm hoping. This is a very nice MPC3000. I think the person who packed it didn't do a good job. Its a shame cause other than that the unit was well taken care of. I've been stressing about this for the last few hours. I hope I can purchase these parts.

If you cannot get them from VST, then try Forat. I am sure they have lots of extra sides given all the ones they have put wooden replacements.

Then again, you could get the wooden ones from them.

I would just have a local wood shop make some. You could probably get them for $200 or less. VST and Akai/Numark does not carry the LE sides. Forat may have them.