By Mink
Thu May 07, 2015 7:54 pm
Not entirely sure this is technically feasible, but if it is - would like this to be implemented....
At present, if I start the MPC software but at some point during the session want to plug in another MIDI controller (say, a keyboard), the device does not show in the MIDI options unless I shut the application down and re-start. This can be a pain mid-workflow.
It would be good if under the MIDI options there is an option to re-scan for active MIDI input devices, to avoid having to quit/re-start
At present, if I start the MPC software but at some point during the session want to plug in another MIDI controller (say, a keyboard), the device does not show in the MIDI options unless I shut the application down and re-start. This can be a pain mid-workflow.
It would be good if under the MIDI options there is an option to re-scan for active MIDI input devices, to avoid having to quit/re-start