MPC Software & MPC Beats Forum: Bug reports, feature suggestions and discussion for the MPC Software and the free 'MPC Beats' application for Mac/PC. If you have hardware-specific questions, please post in the relevant MPC sub-forum.
By Nap41stSide Sun Aug 19, 2018 11:40 am
Hi guys I have a question for long time users of the software.

So Im using 1.9 version and I always like to use Software's built in Filters located on the Program Edit section.
In other words I open Prgm Edit, and I select All Pads to run through my LP or HP filter.
The thing is that when I do that, I can no longer use the velocity for any event on this Program.
When I decrease the velocity of any little brick of my pattern, the cutoff of the filter drops down instead of the level of this certain brick.

Is this supposed to happen ? Is this going on in the latest updates of the software too ? Im I missing something here ?

I would appreciate some help on this because it disrupts my process a lot of times in a very irritating way

Thank you in advance