By TL4AU
Thu Sep 20, 2018 12:42 am
Looked through a lot of old threads on the subject but didn't find this problem or answer anywhere...
Running the Akai MPC 1.9.7 64-bit along with Reaper 5.95 64-bit
Studio is run in as MIDI and the VSTi MPC Akai Professional 2 -32ch. Main Akai software pops up after adding FX. Load program onto pads like normal and then can hear the drums sounds like normal while playing them. Reaper recognizes the sounds because the yellow bar moves with the pad noises. Problem is it doesn't record any of the sounds.
Setting it up was too easy for the solution to be that difficult... I just can't figure it out and again - none of the threads I've read sound like this problem. Any links to a previous solution or advice in general?
Thanks
Running the Akai MPC 1.9.7 64-bit along with Reaper 5.95 64-bit
Studio is run in as MIDI and the VSTi MPC Akai Professional 2 -32ch. Main Akai software pops up after adding FX. Load program onto pads like normal and then can hear the drums sounds like normal while playing them. Reaper recognizes the sounds because the yellow bar moves with the pad noises. Problem is it doesn't record any of the sounds.
Setting it up was too easy for the solution to be that difficult... I just can't figure it out and again - none of the threads I've read sound like this problem. Any links to a previous solution or advice in general?
Thanks