By banditbeatsofficial
Wed May 10, 2023 10:43 pm
I am using MPC software with the MPC X.
Just installed the latest update (Install-MPC-v2.11-2.11.9.33-release-Windows). 5 minutes into using the firmware, it completely freezes mid-sequence. I am unable to save, exit, or do anything.
This is unusual because I've been using the MPC X and MPC Software for 3-4 years and quite honestly have never experienced a crash. Maybe I'm lucky, but I also have an extremely powerful PC.
Has anybody else experienced this at all?
Thanks,
Bandit Beats Official
Just installed the latest update (Install-MPC-v2.11-2.11.9.33-release-Windows). 5 minutes into using the firmware, it completely freezes mid-sequence. I am unable to save, exit, or do anything.
This is unusual because I've been using the MPC X and MPC Software for 3-4 years and quite honestly have never experienced a crash. Maybe I'm lucky, but I also have an extremely powerful PC.
Has anybody else experienced this at all?
Thanks,
Bandit Beats Official