Driver for MPC One - Osx, connection to MPC Software.

Hi,
I Just bought an MPC One, and I've been using it as standalone for some days now.
I also connected it to my MacBook Pro 16 - Osx 10.15.4, and could without a problem apply the MPC 2.7.2 Updater from there to the MPC One. So, I know the computer recognizes the MPC One.
When I try to go in controller mode, the MPC One shows "looking for computer", and the MPC Software shows "Driver installation error" The MPC drivers were not installed properly...Please reinstall the following drivers.
But I can't find any driver on Akai's website, and no one is mentioned in the downloads section of the MPC One section.
Tried to contact Akai's support several days ago, but no answer yet.
Thank you for your help.
Best wishes,
Fred

The drivers are in the 2.7.2 MPC Software installer (not the firmware installer) - re-run the installer, select MPC One and on the right there should be options to install the driver. Reboot after installation.

10.15.4 Might not be supported yet didn’t that just come out? And you ran the software installer again and selected driver install using the mpc one icon?