is it possible to recover recording after battery dies

Hi

I recorded something and walked away from my MPC Live 2, unplugged.
When I came back it had powered down, and I didn't save it. Are the recordings stored somewhere in a temporary folder perhaps?

Thanks
Mike

Gano wrote:Hi

I recorded something and walked away from my MPC Live 2, unplugged.
When I came back it had powered down, and I didn't save it. Are the recordings stored somewhere in a temporary folder perhaps?

Thanks
Mike

No. Work in progress is stored into RAM, and RAM gets flashed when not connected to power. I am afraid your work is lost.

Hahaha That happened the other day. I was Pissed! Yea Its a Wrap

Just use the autosave feature if you’re planning to work like this..
You could check the project’s data folder if your recordings are stored but don’t get too much hope..

Only Thing i dont like about the AutoSave feature...is that it will Pause EVERYTHING and "Autosave". It dont matter if you're recording or anything lol. Other than that...Its a Good Feature