By Dan Batts
Wed Aug 31, 2022 10:59 am
MPC One on 2.11.1 (but it did it on 2.10 too).
Hitting Double Length sends program change messages to two of the synths I have connected over USB (Microfreak and Modal Skulpt). Unintended and unwanted and by now very irritating. Anyone else run in to this?, and if so, have you found a fix?
I’ve had a good look on the web, on MPC forums and searching for a fix for the specific synths. On the MPC I’ve tried different settings in MIDI/SYNC preferences, set Program change and bank msb/lsb to Off, checked list view (it shows no program change message has been sent).
Any help or ideas appreciated
Cheers
Dan
Hitting Double Length sends program change messages to two of the synths I have connected over USB (Microfreak and Modal Skulpt). Unintended and unwanted and by now very irritating. Anyone else run in to this?, and if so, have you found a fix?
I’ve had a good look on the web, on MPC forums and searching for a fix for the specific synths. On the MPC I’ve tried different settings in MIDI/SYNC preferences, set Program change and bank msb/lsb to Off, checked list view (it shows no program change message has been sent).
Any help or ideas appreciated
Cheers
Dan