clicks in loops

jpeg wrote:some times if the click is at the beginning its easier to just adjust the attack envelope to smooth that out

but it doesn't apply in loops , only crossfading does

SakisX wrote:Doesn't always apply to stereo samples , but definitely it helps

Oh yeah if you're using a stereo file, good luck finding two zero points that line up between the two channels. That's almost impossible so make sure you have your crossfade on if you really have to have a stereo sample.

Whatever the Zero snap doesnt Declick, Attack in the Amp Envelope should clean it up

SOLUTION! I SOLVED IT! ok so my loops are cut perfectly and i imported ableton project to the force and there were these annoying poos at the start/end of my loops.

I use an internal ssd also. I tried all the settings but essentially all i needed to do was re upload each loop by selecting it and then SAVE AS and give it a new name and save it internally onto the force instead of my drive. Not sure if it would work if i just resaved it anywhere because i havent tried yet.

Disc streaming is amazing and makes up for lack of ram so dont worry about disabling that.

Was very frustrsting and i almost got a refund! Also its worth noting that i tried reuploading the loops and just saving it but when i switch off and on again the loop pop artefact was back!!!

Summary: re upload the problem loops manually and save as a new project on the force