Using q-link to "pitch bend" one actave

Hi,

I am new here and quite new to my MPC One. On my old MPC 1000 I often had the q-link faders mapped to pitch over the range of one octave, which I used extensively when performing live.

However, I cannot figure out how to do this with my MPC One (drum program). I only managed to control pitch over two octaves, but that wasn't very useful, and I couldn't figure if there was a way to set a range.

Can anyone help?

Thank you!

Lampdog wrote:Welcome.

Did you try looking through Q-LINK edit?

Pay attention to the tabs at the bottom while you’re in there.
Look for TUNE /or SEMI-TUNE when configuring.

This is in the manual.

Hi and thank you!

Yes I tried that, but was only able to find the "Global Semi Tune" option, and I cannot find a place to set the range for that so it only covers one octave instead of 4 octaves. Am I looking in the wrong place?

...Oh it seems like this is coming in MPC 3.0, lucky me