By Zoelastik
Sun Jul 12, 2026 1:29 pm
Hi there,
A tricky question about internal mixer routing.
HW used :
- MPC Live Gen1 - Fw3.9
- Behringer UMC1820 audio interface
- A pair of monitor plugged on the behringer OUT1/2
- A TC-Clarity stereo plugged on the SPDIF behringer OUT11/12
- A BoredBrain Optx V1 ADAT 8in/8out plugged on the UMC1820
My goal : monitoring the master channel of the MPC (OUT1/2) with the TC-Clarity to have a better view of what's going on
I'am currently using a the submix8 as a master going to the SPDIF OUT 11/12 to display the output on the TC Clarity.
I then use the send4 on the submix to route the audio out on my monitor OUT1/2.
It work, but i'am pretty sure there would be a better/clean way to do it.
Does anyone as a suggestion to improve this setup ?
A tricky question about internal mixer routing.
HW used :
- MPC Live Gen1 - Fw3.9
- Behringer UMC1820 audio interface
- A pair of monitor plugged on the behringer OUT1/2
- A TC-Clarity stereo plugged on the SPDIF behringer OUT11/12
- A BoredBrain Optx V1 ADAT 8in/8out plugged on the UMC1820
My goal : monitoring the master channel of the MPC (OUT1/2) with the TC-Clarity to have a better view of what's going on
I'am currently using a the submix8 as a master going to the SPDIF OUT 11/12 to display the output on the TC Clarity.
I then use the send4 on the submix to route the audio out on my monitor OUT1/2.
It work, but i'am pretty sure there would be a better/clean way to do it.
Does anyone as a suggestion to improve this setup ?