By koralfx
Wed Mar 11, 2020 7:50 pm
Hello everyone.
1.
My first question is about the midi volume slider (track with midi program). Until the slider is touched, track does not send message #CC7 at the start of the sequence. However, if you change the value once, then track sends this message at the start of the sequence. This cannot be seen in the track automation. Is it possible to turn it off? Usually midi sliders have a value of 0-127 and OFF. It's not here.
The only way you can clear the entire track. The same applies to the PAN knob.
2.
Second question. When you do automatic volume, only one point, at the very beginning of the track (1.0.0), then three #CC7 messages are sent. Is it normal? Of course, the same applies to the PAN knob.
Other standard CC messages are sent twice.
3.
After pressing stop, 16 messages are sent #CC64 = 0 (sustain off), but all on the same channel (depending on the track setting). Why 16? Is this a bug? On separate channels it would make sense.
All questions relate to MPC Live and MPC Software.
Thank you very much in advance for your answers.
Regards
koralfx
1.
My first question is about the midi volume slider (track with midi program). Until the slider is touched, track does not send message #CC7 at the start of the sequence. However, if you change the value once, then track sends this message at the start of the sequence. This cannot be seen in the track automation. Is it possible to turn it off? Usually midi sliders have a value of 0-127 and OFF. It's not here.
The only way you can clear the entire track. The same applies to the PAN knob.
2.
Second question. When you do automatic volume, only one point, at the very beginning of the track (1.0.0), then three #CC7 messages are sent. Is it normal? Of course, the same applies to the PAN knob.
Other standard CC messages are sent twice.
3.
After pressing stop, 16 messages are sent #CC64 = 0 (sustain off), but all on the same channel (depending on the track setting). Why 16? Is this a bug? On separate channels it would make sense.
All questions relate to MPC Live and MPC Software.
Thank you very much in advance for your answers.
Regards
koralfx