8 outs on MPC X

Hey....I just got the X a few weeks ago and I'm running into a problem. Actually 2 problems.
1. Is there any way to use ALL 8 outs on the X individually? I'm trying to track a beat out and have all 8 outs connected to my Soundcraft mixer/interface which is going into Studio One 5. Everything is fine except for outputs 1&2 . When I turn the volume all the way up and turn the direct/ main knob up, the other pads bleed into 1&2....that's because I have the main volume up right ? But when I turn the main volume all the way down and turn the direct/ main knob to "direct" I get all the outputs except 1&2.....Is anybody using all 8 outs directly or is this impossible?

I have not had that problem before on the X... can you describe your setup a bit more, there might be something else causing bleeding.

Honestly, I was actually expecting you to complain about how the 1&2 are joined at the hip and require hard panning to use as individual outputs...

NearTao wrote:I have not had that problem before on the X... can you describe your setup a bit more, there might be something else causing bleeding.

Honestly, I was actually expecting you to complain about how the 1&2 are joined at the hip and require hard panning to use as individual outputs...

That's what I'm talking about

i think some EFX are 'bleeding' out from 1/2