How to control my HW qlinks with a midi controller

I have a midi fighter twister that would be great to access all 16 qlinks for my live2, but I can't figure out how to make them.
They're not listed in the middle learn section, and the HW section seems to be about how the qlinks map to midi out, correct?
The qlink edit page is also not looking promising.

TIA!
Mike

Gano wrote:I have a midi fighter twister that would be great to access all 16 qlinks for my live2, but I can't figure out how to make them.
They're not listed in the middle learn section, and the HW section seems to be about how the qlinks map to midi out, correct?
The qlink edit page is also not looking promising.

TIA!
Mike

Try this video for a starting point. In standalone not everything is mapable like the software on desktop.

Yep. I've seen that video and scoured pretty thoroughly online for an answer with no luck, hence why I'm turning to the forum. And definitely looking for a standalone solution.

I'm wondering if I can access the qlinks (1-16) by referencing a particular channel and control number that I can then set my mf twister to.

I would then get a lot more mileage out of it since the controller is now context aware.

still looking for this, would love to assign MIDI knobs to the Q-Links so that they control different program parameters when going to a different program

someone said there was a workaround that was discussed somewhere, but couldn’t find anything i guess if someone works out something they would share here

I think it’s possible if you put the alternative firmware on the hardware, that gives access to the internal drive , you then create the desired mappings in the software, export the mapping file , then copy it to the hardware .
There is a better explanation on github.
https://github.com/TheKikGen/MPC-LiveXplore