By Yentz
Wed Dec 30, 2020 6:59 pm
Hi,
my MPC one stopped working in controller mode. Link seems to work now and then and the moc says connected to ethernet.
The networktool I reinstalled a couple of times says sometimes it is connected sometimes it isn't.
Before this started I saw really weird behaviour in form of some "waiting dots" probably the counterpart to the spinning ball on os x.
Sometimes it statts straight into controller mode sometimes it doesn't.
I looked at the menu with the three buttons on startup but dont have an barcodescanner to check ethernet. There is still warranty so it isn't too bad but really annoying as it will probably take ages until I have it back.
The screen gets pretty warm in the upper left.
Sometimes when I shut down it doesn't even ask if I want to save the project.
In case there is an easy fix please let me know.
Thanks for helping
my MPC one stopped working in controller mode. Link seems to work now and then and the moc says connected to ethernet.
The networktool I reinstalled a couple of times says sometimes it is connected sometimes it isn't.
Before this started I saw really weird behaviour in form of some "waiting dots" probably the counterpart to the spinning ball on os x.
Sometimes it statts straight into controller mode sometimes it doesn't.
I looked at the menu with the three buttons on startup but dont have an barcodescanner to check ethernet. There is still warranty so it isn't too bad but really annoying as it will probably take ages until I have it back.
The screen gets pretty warm in the upper left.
Sometimes when I shut down it doesn't even ask if I want to save the project.
In case there is an easy fix please let me know.
Thanks for helping