By jamos
Fri Mar 15, 2024 8:46 pm
I'm starting to use Reaper in conjunction with my MPC Live and am already stubbing my toes. I have created a project in the MPC at 123 BPM; exported those tracks as wavs, and then loaded them into a Reaper project, with its tempo also set to 123 BPM. However, the beat markers in Reaper are way off from the actual beats in the recordings, by almost a measure after 60 bars. I expect some alignment issues, but not that severe.
Also, when I start the two devices simultaneously - Reaper and the MPC - they drift apart at a rapid rate. Again, I do not expect them to sync up since I can't start them precisely together, but they should run at the same rate and not drift - these are recordings created in the MPC, after all.
If I perform the same operations with the MPC and Adobe Audition, everything works fine.
What's going on here? (V 2.13)
Also, when I start the two devices simultaneously - Reaper and the MPC - they drift apart at a rapid rate. Again, I do not expect them to sync up since I can't start them precisely together, but they should run at the same rate and not drift - these are recordings created in the MPC, after all.
If I perform the same operations with the MPC and Adobe Audition, everything works fine.
What's going on here? (V 2.13)